The Process

Applying the 3D fluid graphics is a four part process.

1.  The part is cleaned / degreased and allowed to dry.  If any restoration work (gouges, nicks etc need to be fixed this will be done at this time.

2.  Base coat / primer is applied and allowed to dry.

3.  Film is cut to desired length and placed on water in a temperature / PH controlled tank.  An activator is sprayed on the film and part is dipped into the tank at the correct angle to insure even coating without stretching and breaking the film.  Part is rinsed in clean water to remove any excess film and allowed to dry.

4.  Automotive top coat is applied and allowed to dry.